BBBAccredited Business
Our handyman specialists install and repair retractable, fixed, and freestanding awnings, mounted securely into wall framing or fascia, level and correctly pitched for water runoff, and adjusted to operate smoothly.
Professional Solutions
Awning installation is a structural mounting job, a retractable patio awning can span 15 to 20 feet and carry significant wind load in a partially extended position, and the wall or fascia mounting brackets must be fastened into structural framing to handle those loads. Mounting into stucco, siding, or fascia without hitting the framing behind it produces a mounting that holds fine in calm weather and fails in the first windstorm. Kaminskiy Care and Repair’s handyman specialists locate wall framing before any awning bracket is drilled, use through-bolts or structural lag screws into solid framing, and pitch the awning at the correct angle for water runoff so pooling on the fabric does not accumulate and accelerate wear. With crews across the United States, a securely installed awning is a call away.
An awning mounted into stucco or siding without hitting the framing behind it will pull out of the wall under wind load, the scenario that causes the most awning installation failures. Our handyman specialists locate wall framing and fasten into it with structural hardware before any awning bracket is installed.
Wall studs or fascia blocking are located and confirmed before awning brackets are drilled, no surface-only mounting that fails under wind load.
Awnings are pitched at a minimum 1:5 slope toward the outside edge so water runs off rather than pooling on the fabric, standing water accelerates fabric degradation and adds load to the mounting.
Retractable awnings are extended and retracted through the full range of motion and the tension adjusted so the arm operates smoothly and the fabric is taut when extended.
We stand behind our awning installation and repair workmanship.
BEFORE
AFTERRetractable patio and window awnings installed with brackets fastened into wall framing or structural fascia, pitched for drainage, and with the retraction mechanism adjusted for smooth full-range operation.
Fixed window awnings, door canopies, and freestanding shade structures installed level, pitched for drainage, and fastened with the hardware appropriate for the wall and the awning load.
Bent awning frames straightened or replaced, fabric panels replaced when torn or UV-degraded, and motorized awning controls and sensors repaired or replaced.
Fixed, freestanding and retractable awnings, mounted into the structure, not just the stucco.
An awning is only as good as what it is bolted to. We find the framing behind the stucco or siding, set the brackets level and through-bolted, seal every penetration, and set the pitch so rain runs off instead of pooling. Fabric, aluminum or retractable, the mounting is the job.
Every one of these is an awning job for a Kaminskiy-certified technician. Call now. Most awning installs and repairs are finished in one visit.
We answer in under three rings and get you priced and scheduled in minutes.
A clear, written quote with upfront pricing. You approve before work begins.
Kaminskiy-certified pros finish the job with a workmanship warranty.
Every job is backed in writing by our workmanship warranty and done by a Kaminskiy-certified, background checked technician.
A fixed awning gives shade all day and needs no attention. A retractable one lets the winter sun in and rolls away in high wind. Which one suits you depends on the exposure and how you use the space.
An awning catches wind like a sail. Brackets have to land on framing, not just stucco or siding, and every bolt hole has to be sealed. That is where most awning failures start.
A fixed awning needs enough slope for rain to run off the front edge. Too flat and water pools, stretches the fabric and pulls on the mounts. We set the pitch before the first bracket goes in.
Fabric is lighter and comes in any color but wears in the sun. Aluminum lasts for decades with little care. We help you match the material to the climate and the look of the house.
Can't find your answer? Call 919-585-1114 and ask us anything.
Call 919-585-1114Yes. Bring the awning and we handle the mounting. Before you order, send us a photo of the wall and the measurements of the opening. We check that there is framing where the brackets need to land and that the wall can take the load, so the right awning arrives the first time.
The framing of the house. Stucco and siding alone will not hold an awning in wind. We locate the studs, headers or rim joist behind the finish, through-bolt or lag the brackets into them, and seal each penetration against water. On a masonry wall we use rated sleeve anchors.
In most cases, yes. Stretched or broken arm springs, a bent arm, a slipping gearbox, a motor that stopped responding and torn fabric can all be fixed or replaced on the existing frame. If the frame itself is bent, we tell you whether a repair makes sense.
Usually not for a window or door awning on a house. A large patio cover, a commercial awning over a public sidewalk, or anything in a homeowners association may need approval first. We tell you before we start if your project is one of those.
It depends on the awning size and type, what the wall is made of, how high the mount is and whether an old awning has to come down first. A retractable unit with a motor takes longer than a fixed fabric awning. You get the price in writing before we start.
Tell us about the wall, the opening and the awning you have in mind. We'll call you back with a price and a time. Calling is still the fastest way: 919-585-1114.
Free quotes. Kaminskiy-certified technicians. A workmanship warranty on every job.
We answer in under three rings, 24/7.No price games. You get a clear written quote before any work begins, backed by our workmanship warranty.
