Sagging block-wall gates rehung square, RV gates braced, pool gates closing on their own. Priced on the call, usually finished in one visit.


Kaminskiy Care and Repair repairs fences and gates across Phoenix, from the historic districts and Arcadia to Moon Valley, Ahwatukee and Desert Ridge. Gates hung on block walls are rehung square with new hinges and latches, RV gates are braced so they stop dragging, pool gates are set to close and latch on their own, and sun-split wood gates and fence sections get matched boards. You get the price on the call, in writing, before anything is scheduled. From our office on Central Avenue downtown, open every day.
Eight repairs, one crew, priced before we come out.
Phoenix gates fail from the top down. The sun warps the wood slats and bakes the finish, a monsoon gust slams the gate until the hinge post works loose in the block pilaster, and dust and heat finish off the latch. We rehang the gate on hinges sized for its weight, reset or replace the post, fit a latch that catches with one hand, and match the slats. Same gate, swinging true. Our office is on Central Avenue, so we are never far.
Post Reset
Picket & Plank Swap
Gate Rescue
New Wood Gate
Section Rebuild
Storm & Wind Damage
Hinges & Latches
Stain & SealEvery one of these is a quick fix for a Kaminskiy-certified technician. Call now. Most Phoenix fence and gate repairs are priced on the call and finished in one visit.

Priced and on the calendar during the first call.

A written quote you approve before anyone drives out.

One visit, truck stocked, warranty in writing.
A one-year workmanship warranty, in writing, on every Phoenix fence and gate repair.
Sun and wind. A west-facing wood gate takes a hundred and fifteen degrees in July, so the slats cup and split and the finish lets go in two summers, not ten. The monsoon brings gusts that slam a gate against its stop until the hinge post loosens in the block pilaster, and the dust gets into every latch and roller. The block wall itself is fine. The gate hung on it is what wears out, and a rehang on proper hinges, a sound post and a latch that catches brings it back.
Not for a repair. Phoenix exempts a fence up to three feet from a building permit and handles a new wall or fence from three to six feet on a zoning and drainage permit. Rehanging a gate, replacing hinges and slats or resetting a post changes nothing and needs nothing. A new wall, a taller fence or a new opening cut in a block wall is where we check with the city first.
Most Phoenix gate calls are a rehang: new hinges sized for the weight, a post reset, a latch that lines up, slats matched. That is the work we do, and it costs a fraction of a new gate. A wood gate past saving gets a new one built on site to match. Block-wall construction, welding, new iron and electric openers are not our lane, and we tell you on the call if that is what the gate needs.
Arizona's pool barrier statute, and Phoenix's own code with it, wants the pool enclosure at least five feet high with a gate that closes and latches on its own, swings outward away from the water, and has its latch at least fifty-four inches up or on the pool side. A pool gate that drags open or will not latch is the first thing we fix, and we check the hinge tension, the latch height and the gap under the gate while we are there.
Low picket and wood fences, side-yard wood gates and the odd iron gate on the 1920s to 1940s bungalows. The posts rot where the irrigation runs and the gates sag in frames that settled decades ago. We reset the posts, rehang the gate and match the pickets so the street face stays the way the district expects.
Block walls from the 1950s through the 1970s with wood side gates on steel posts, big flood-irrigated yards and the first generation of RV gates. The gate post works loose in the pilaster, the slats split in the sun and the RV gate drags across the drive. We rehang, re-slat and brace them, and fit a drop rod that finds its hole.
Stucco homes from the 1980s on with block walls, iron and wood-and-iron gates, pool barriers and association rules on the color and style. The pool gate stops latching, the hinges rust and the view-fence latch bends. We rehang and re-latch to the approved look, with the hardware and finish in writing for the form.
We price the repair on the call, in writing, before anything is scheduled.
Posts, rails, pickets, hardware and concrete come along, so a post reset, a picket swap or a gate rehang is finished on that first visit.
A gate that is done gets a new single wood gate built on site, up to four feet wide. A fallen section is rebuilt on the existing posts.
The work area is cleaned before we leave, and every repair carries our one-year workmanship warranty.
Phoenix exempts a fence up to three feet from a building permit and puts a new wall or fence between three and six feet on a zoning and drainage permit; six feet is the usual limit at the side and rear, and a fence in the front setback stays low. A like-for-like repair changes nothing: rehanging a gate, swapping hinges and slats, resetting a post or rebuilding a wood section needs no permit. A new or taller wall, or a new opening cut in a block wall, is where the city comes first.
Arizona's pool barrier statute sets the floor and Phoenix's own pool code follows it: a barrier at least five feet high with no opening a four-inch ball could pass, and a gate that closes and latches on its own, opens outward away from the pool, and carries its latch at least fifty-four inches above the ground or on the pool side at least five inches below the top. If your pool gate drags open or the latch no longer catches, that is the first thing we fix.
Ahwatukee, Desert Ridge, Laveen and most of the newer communities are association neighborhoods. A gate rehung and painted to the scheme rarely needs a form; a new gate, a different style or a new color usually does, and we put the materials and finish in writing for it. In Willo, Coronado, Encanto-Palmcroft and the other historic districts a fence or gate visible from the street is reviewed when it changes; a repair that puts back the same material in the same profile is maintenance.
Can't find your answer? Call 480-637-5830 and ask us anything.
Call 480-637-5830We answer in under three rings, price most fence and gate repairs on the call, and usually schedule within days. The technician brings hinges, latches, posts, slats, concrete and a drop rod, so a rehang, a post reset or a pool gate fix is finished in one visit, from our office on Central Avenue downtown.
Yes. The wall stays; the gate is what we work on. We pull the loose hinge post and reset it, or replace it, hang the gate on hinges sized for its weight, line up the latch and match the slats. Kaminskiy Care and Repair is bonded and insured, and a job that turns out to need a block mason or a welder goes to one, which we say on the call.
It depends on three things: whether the post is sound, how much of the gate needs new wood or hardware, and how heavy the gate is. Tell us what the gate is doing, or text a photo, and we give you the price on the call, in writing, before anything is scheduled. No surprises at the house.
Yes. An RV gate is wide and heavy, so it sags, drags and takes two people to open. We square the frame, brace it, fit hinges that carry the weight, reset the posts if they have moved, and set the drop rods and the center latch so it opens and closes with one hand. Welding a cracked frame or adding an opener is not our lane, and we tell you if that is what it needs.
The law wants it to close and latch on its own, swing out away from the pool, and carry its latch at least fifty-four inches up or on the pool side. We check all three, adjust or replace the self-closing hinges and the latch, and close the gap under the gate. If the barrier itself is short or has a climbable spot, we tell you what the inspector would say.
No. We repair gates and wood fences: hinges, latches, posts, slats, pickets, rails, sections, pool gates and staining. Block-wall construction, welding, new iron and electric gate openers are not our lane. If your wall or gate needs one of those, we tell you on the call and still fix what can be saved.
All of Phoenix from Central Avenue, including Arcadia, the Biltmore area, North Central, Willo, Coronado, Encanto-Palmcroft, Moon Valley, Sunnyslope, Laveen, Ahwatukee, Desert Ridge and Deer Valley, plus Scottsdale, Paradise Valley, Tempe, Glendale and Peoria. Call 480-637-5830 to confirm your address and get on the schedule.
Describe the fence or gate, or text a photo of it, and we call back with a written price and a time. Calling is still faster: 480-637-5830.
Priced on the call, fixed in one visit, warranted in writing.
We answer in under three rings, 24/7.No price games. You get a clear written quote before any work begins, backed by our workmanship warranty.





